Bestway 58623E - User Manual

Questions and Answers

M
Melanie ContrerasJul 29, 2025
Why is my Bestway Swimming Pool Cleaner not picking up debris?
- M
  Miranda BoyerJul 29, 2025
  There are several reasons why your Bestway Swimming Pool Cleaner might not be picking up debris: * The battery may be running low. If so, charge the robot again. * The impeller might be jammed. Power off the robot and inspect the hole under the swivel head for any obstructions. * The suction mouth could be clogged. If so, remove any objects blocking it. * The debris compartment may be full. If this is the case, clean both the debris compartment and the filter cover.
R
Rachael DouglasAug 3, 2025
How to fix a Bestway Swimming Pool Cleaner that doesn't cover the entire pool?
- W
  Willie LawsonAug 3, 2025
  If your Bestway Swimming Pool Cleaner isn't covering the entire pool, here are a few potential causes and solutions: * The debris compartment might be full. Clean the debris compartment. * The operation time might be shorter than expected. Clean the filter compartment and recharge the robot for 6 hours. * Water circulation from the filtration system may be interfering with movement. Turn off the filtration system at least 15 minutes before operating the robot. * The wheel might be jammed. Check and remove any debris from the wheel. * The locking pin position may not be set properly. Adjust the locking pin position according to the instructions. * Algae may be making the pool floor slippery. Scrub the pool bottom and the robot wheels to remove the algae.
D
Donald KramerAug 8, 2025
What to do if Bestway Swimming Pool Cleaner moves slowly or not at all?
- L
  Linda WatsonAug 8, 2025
  If your Bestway Swimming Pool Cleaner is moving slowly or not at all, consider these possibilities: * The debris compartment may be full, or the filter cover may be clogged. Clean the debris compartment and flush the screen with water. Use a soft brush to gently clean the screen, ensuring the filter cover is in place before the next use. * The suction mouth could be clogged. Remove any obstructions from the suction mouth. * The impeller might be jammed. Turn off the robot and check the hole under the swivel head for any large debris.
D
Donna FernandezAug 13, 2025
Why is the swivel head on my Bestway Swimming Pool Cleaner not turning?
- J
  John CarterAug 13, 2025
  If the swivel head on your Bestway Swimming Pool Cleaner isn't turning or is turning noticeably slowly: * The side flap may be obstructed. Check for and remove any debris hindering its movement. * The swivel head bottom might be jammed. Detach the swivel head and smoothening-ring, remove any trapped debris, verify the smoothening-ring and bottom plate are installed correctly, and inspect the smoothening-ring for damage.
M
Misty MillerAug 17, 2025
Why does my Bestway Swimming Pool Cleaner only move along the pool wall?
- S
  scottsmithAug 18, 2025
  If your Bestway Swimming Pool Cleaner is only moving along the pool wall: * The position of the locking pin may not be set correctly, or the robot's facing direction was wrong at the start. Adjust the locking pin setting and ensure the robot's front/back faces the pool wall at the beginning.
E
Emily AndrewsAug 23, 2025
Why does the swivel head on my Bestway Swimming Pool Cleaner rotate repeatedly?
- K
  karensimonAug 23, 2025
  The swivel head on your Bestway Swimming Pool Cleaner may rotate repeatedly for a few minutes after the robot sinks. This is because air is trapped inside the robot. The rotation will stop once the air is discharged, and the robot will begin to move regularly.

Summary

Important Safety Instructions

General Operational and Environmental Safety

Ensure proper immersion, depth limits, and operating temperature for safe use of the robot.

Electrical and Charging Safety

Use correct adaptors, connect to grounded outlets, and disconnect properly before servicing.

User and Hazard Warnings

Restricts use by certain individuals, requires supervision, and warns of suction entrapment hazards.

Maintenance and Warranty Compliance

Handle damaged parts, maintain the filter, and avoid unauthorized battery replacement to preserve warranty.

External Adaptor and Charging Base Safety

Proper Usage and Environment

Use only for intended charging, avoid outdoor use, and protect from environmental elements.

Handling and Maintenance

Keep away from children, disconnect when not in use, and never attempt to open the adaptor.

Cautions for Robot Operation

Usage Limitations

Robot is for underwater use only; avoid pool shocking and use only original accessories.

Pool Environment and Debris

Dissolve salt in saltwater pools; avoid sharp objects and concurrent use with other cleaners.

Charging and Storage Guidelines

Charge indoors in a ventilated area, do not overcharge, and prepare for extended storage.

Troubleshooting Guide

Robot Not Capturing Debris

Check for battery issues, jammed impeller, or clogged suction mouth and clean as needed.

Robot Movement Issues

Address issues like stopping mid-pool, not covering entire area, or moving along walls.

Debris and Flap Problems

Resolve issues with debris escaping, leaking filter covers, or damaged suction mouth flaps.

Charging and Operation Time

Troubleshoot short operation times, non-charging issues, or external adaptor problems.

Bestway 58623E Specifications

General

Pool Type	Above Ground
Color	Blue
Material	Plastic
Hose Diameter	1.25 inches
Type	Automatic
Compatibility	Compatible with most above ground pools

Related product manuals

Bestway FLOWCLEAR 58649