Congratulations on the purchase of your new Lay-Z-Spa™. Before
operating the Lay-Z-Spa™ be sure to follow these 14 steps.
Damage resulting from misuse is not covered by the
manufacturer's warranty.
™
1
The Comfortable, Affordable, Go-Anywhere Spa!
™
1
The Lay-Z-Spa™ should not
be setup or left out in
temperatures lower than
Û&Û)
)LOOWKHZDWHUOHYHOEHWZHHQ
maximum and minimum
printed on the SPA wall.
Water
Level
MAX
MIN
3
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
4
Check and ensure the Spa and
adapters are not leaking.
6
If the pump not heating properly,
please press the thermal cut-out
manual “Reset” button on
the pump.
9
+LEHUQDWH)XQFWLRQ
After 72 hours of
operationH[FHSWWLPHU
IXQFWLRQ
the pump will hibernate and
“END” will be display on the LED. When
the pump is hibernating both the rapid
heating and water filtration functions are
disabled. To re-active the pump simply
press any button on the control panel.
11
The PRCD must be tested
before each use.
2
10
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
&KDQJHWKH)LOWHU&DUWULGJHV
regularly
8
he
&OHDQDQGPDLQWDLQWKH)LOWHU
Cartridge regularly.
7
that the
en
Be sure to set your
desired temperature.
5
RESET
TEST
,03257$17127,&(
This unit will auto lockout after
5 minutes of inactivity.
To simply place a finger
over function button
for 3 seconds.
12
We recommend you take a shower
before using your Lay-Z-Spa, as
cosmetic products, lotions, and other
residues on the skin can quickly
degrade water quality.
13
14
B[FPBB欧规SPA快速操作14步骤说明书插页B英
To Next Page
Need help?
General
