6.2 VTX Frequency and Power Switching
Cetux X Whoop Quadcopter (Betaflight version) uses M04 VT X with a maximum power
of 400mW Changing frequency and output power value through buttons is not
supported by this VTX. To configurate these values, please access OSD Menu in the
Betaflight firmware.
Path for configurating VTX BAND:
Path for configurating VTX power value:
Interface for Configurating VTX setup is shown as below:
SMARTAIJDIO
F R2 5695 400
> BAND
CHAN
(FRED
POWER
PIT
SAVE
CONFIG
BACK
RACEBAND
2
5695
400
OFF
NOTE: After changing the VTX band or power, please press (SAVE) on the interface for changes to be
activated
NOTE: Please do not leave a powered-on quad to sit still (above 1 minute) when the VTX power is set
to be above 100mW. This can cause overheating of VTX and malfunctioning of the hardware.
27
To Next Page
Loading...
