3. Quick Start Guide
3.1 Quick Start
Before flying, verify that the remote control radio transmitter is successfully connected
with the quadcopter, all basic controls are functional, and the quadcopter can be taken
off normally.
Step 1: Take out the remote control radio transmitter and set the throttle joystick and
two switches SB and SC on the top to the lowest position while ensuring that switches
SA and SD are pop-up. Hold the power button on the remote control radio transmitter
for 5 seconds until it beeps three times, and then release. When the remote control
radio transmitter power indicator turns from flash red to solid blue, it means the
transmitter has been successfully powered on
Set the Throttle, SB and SC to the Lowest Position and
Ensure That Switches SA and SD Are Pushed Up
Step 2: Install two batteries into the battery mounting slot under the quadcopter.
Connect the quadcopter with the battery, and then place the quadcopter on a
horizontal surface. Wait 3-5 seconds until the green LED on the FC board is on solid,
which represents a complete initialization of the quadcopter and its successful
connection with the remote control radio transmitter.
To Next Page
Loading...
