ExpressLRS use the OpenTX LUA script to control the RF TX
module, like bind or setup.
● Save the ELRS.lua script les onto the radio transmitter's SD
Card in the Scripts/Tools folder;
● Long press the "SYS" button (for RadioMaster T16 or similar
radios) or the "Menu" button (for Frsky Taranis X9D or similar
radios) to access the Tools Menu where you can nd ELRS script
ready to run with only one click;
● Below image show the LUA script run successfully;
LUA Script
MODEL SETUP
Use global funcs
Internal RF
Mode
External RF
Mode
Channel Range
Receiver
OFF
CRSF
CH1-16
00
2/14
● With the LUA script, pilot could check and setup some
congurations of the RF TX module.
ExpressLRS 0bf0d9 0:250
Pkt Rate
TLM Ratio
Power
RF Freq
[Bind]
250Hz(-108dbm)
1:64 (78bps)
500 mW
2.4G ISM
[Wifi Update]
To Next Page
Loading...