Note: The newest ELRS.lua script le is available in BETAFPV Suppo website
(Link in More Information Chapter).
There is a 5D button on the micro RF TX module. Pay attention
only the viical dimention works and the other four dimentions
are invalid. Below is the basic operation of the button and OLED.
Button and OLED
0�250
Pkt. Rate
TLM Ratio
Power
RF Freq
Bind
Wi Update
On the top right. Indicator which tells how many bad
UART packets and how many packets it's getting from
the radio per second. It can be used to conrm the
communication between the radio tansmitter and the
RF TX module is working properly. e.g. 0�200 means 0
bad packets and 200 good packets per second.
RF transmitter packet rate.
Receiver telemet ratio.
RF TX module output power.
Frequency bands.
Set the RF TX module into binding status.
Open the WIFI function for rmware update.
Long Press:
Enter menu page or
change the value of this row.
To Next Page
Loading...