Note: When the RF TX module enters WIFI Upgrade status, the button will be
invalid. Please re-power the RF TX module after rmware update via WIFI.
The Micro RF TX module comes with ocally major release
V1.1.0 protocol and no Binding Phrase inlcuded. So please make
sure the receiver works on ocally major release V1.0.0~V1.1.0
protocol. And no Binding Phrase setted. Micro RF TX module
could enter binding status via ELRS.lua script, as description in
"LUA Script" chapter. Besides, using the button and OLED, move
to the BIND position and long press the button. Then the RF
module will enter binding status.
Bind
Sho Press:
Move to the next row.
Note：When the RF TX module is entering menus page, the binding
between RF TX module and receiver will be lost, the binding will recover
after exiting menus page automatically; you must re-power the receiver
if you have changed the Pkt Rate.
To Next Page
Loading...