BETAFPV Micro - Page 15

Note: The LED will NOT ash when enter binding status. The module will exit
from binding status 5 seconds later auto.
Note: If you reash rmware of the RF TX module with your own Binding
Phrase, please make sure the receiver has the same Binding Phrase. The RF TX
module and the receiver will bind automatically in this situation.
Pkt.rate
TLM Ratio
Power
RGB
500hz
1:128
100mW
White
Update
ExpressLRS
Bind
Pkt.rate
TLM Ratio
Power
RGB
500hz
1:128
White
Update
ExpressLRS
Bind
100mW
Long press the button
could switch the output power.
Micro RF TX module could switch the output power via ELRS.lua
script, as description in "LUA Script" chapter.
Besides, using the button and OLED, move to the Output
position. Long press the button could switch the output power.
Output Power Switch
long press the button.
Then the RF TX module will enter binding status.