27
Permissible stor-
age conditions
- 25 °C to + 55 °C, ≤ 93 % relative air humid-
ity, 700 –1060 hPa ambient pressure
Power supply
4 x 1,5 V AA batteries
Battery life For approx. 250 measurements, depending
on the blood pressure level and/or pump
pressure
Classification Internal supply, continuous operation, type
BF applied part, IP22, no AP or APG
The serial number is located on the device or in the battery
compartment.
Technical information is subject to change without notification
to allow for updates.
•
This unit is in line with European Standard EN 60601-1-2 (In
accordance with CISPR 11, IEC61000-3-2, IEC61000-3-3,
IEC61000-4-2, IEC61000-4-3, IEC61000-4-4, IEC61000-4-5,
IEC61000-4-6, IEC61000-4-8, IEC61000-4-11) and is subject
to particular precautions with regard to electromagnetic
compatibility (EMC). Please note that portable and mobile HF
communication systems may interfere with this unit.
•
This device is in line with the EU Medical Devices Directive
93/42/EEC, the „Medizinproduktegesetz“ (German Medical
Devices Act) and the standards EN1060-1 (non-invasive
sphygmomanometers, Part 1: General requirements),
EN1060-3 (non-invasive sphygmomanometers, Part 3: Sup-
plementary requirements for electro-mechanical blood pres-
sure measuring systems) and IEC80601-2-30 (Medical elec-
trical equipment – Part 2 – 30: Particular requirements for the
safety and essential performance of automated non-invasive
blood pressure monitors).
•
The accuracy of this blood pressure monitor has been care-
fully checked and developed with regard to a long useful
life. If using the device for commercial medical purposes, it
must be regularly tested for accuracy by appropriate means.
Precise instructions for checking accuracy may be requested
from the service address.
11. Mains part
Model no. LXCP12-006060BEH
Input 100 – 240 V, 50 – 60 Hz, 0.5 A max
Output 6 V DC, 600 mA, only in connection with
beurer blood pressure monitor.
Supplier Shenzhen Iongxc power supply co., ltd
Protection This device is double insulated and pro-
tected against short circuit and overload by
a primary thermal fuse.
Make sure to take the batteries out of the
compartment before using the mains part.
Polarity of the the DC voltage
connection
Double insulated / equipment class 2
To Next Page
Loading...
