35
average value of the morning measurements for the last 7
days will be displayed. (morning: 5 a.m. – 9 a.m., display
). If you press the memory button M again, the average
value of the evening measurements for the last 7 days will
be displayed. (evening: 6 p.m. – 8 p.m., display ). If you
continue to press the memory button M, the most recent
individual measured values are displayed in turn with the
date and time.
•
The measured values in the corresponding user memory
can be deleted by switching on the device, selecting the
desired user memory, pressing the memory button M and
then pressing function buttons and simultaneously for
5 seconds.
•
The device automatically switches to standby mode (date
and time displayed).
8. Error messages/troubleshooting
In the event of errors, the error message _ appears on the
display.
Error messages may appear if:
•
It was not possible to record the pulse:
E1
;
•
You move or speak during the measurement:
E2
;
•
The cu is fastened too tightly or loosely:
E3
;
•
Errors occur during the measurement:
E4
;
•
The pump pressure is higher than 300 mmHg:
E5
;
•
The batteries are almost empty :
E6
.
In such cases, repeat the measurement. Ensure that you do
not move or speak.
If necessary, reinsert or replace the batteries.
9. Cleaning and storing the unit
•
Clean your blood pressure monitor carefully using a slightly
damp cloth only.
•
Do not use any cleaning agents or solvents.
•
Under no circumstances should you hold the unit under
water, as this can cause liquid to enter and damage the unit.
•
If you store the unit, no heavy objects should be placed on
top of it. Remove the batteries. The cu line should not be
bent sharply.
10. Technical specifications
Model no. BM 48
Measurement
method
Oscillometric, non-invasive blood
pressure measurement on the up-
per arm
To Next Page
Loading...
