10
•
Do not drop or insert any object into any opening
or hose. This may damage the unit.
•
Do not press the buttons with excessive force or
with pointed objects.
•
To conserve the batteries, the monitor switches
off automatically if no buttons are pressed for one
minute.
•
The device is only intended for the purpose
described in these instructions for use. The
manufacturer is not liable for damage resulting
from improper or careless use.
•
If you are using the unit for the first time, please
remove the protective film from the display.
•
The monitor can maintain the safety and
performance characteristics for a minimum of
10.000 measure ments or 3 years.
•
Further documents which include information for
the Calibration of the device can be asked at the
service address.
•
The device can be tested in case of supposed
inaccu racy every two years. Please contact the
nearest ser vice address.
Cleaning and storing the device and cuff
To keep your digital blood pressure monitor in the
best condition and protect the unit from damage
follow the directions listed below:
•
C
lean your device and cuff carefully only with a
slightly moistened soft cloth and dry it immediately
with a soft dry cloth. Do not press.
•
W
hen storing the device, make sure that no heavy
objects are placed on top of it.
•
D
o not fold the cuff and tubing tightly. The cuff
tube should not have any sharp kinks and keep it
away from sharp edges.
•
I
f the unit is stored near freezing, allow it to
acclimate to room temperature before use.
•
A
lways store the unit in its storage pouch after use.
•
T
his unit may not meet its performance
specifications if stored or used outside of the
temperature and humidity ranges (see section ’12.
Technical Specifications’).
•
U
se the unit consistent with the instruction
provided in this manual.
To Next Page
Loading...
