Beurer BM 76 - Bluetooth data transfer

19
2. As a measurement concludes, air pressure in the
Cuff will release. The pulse symbol ( ) will display,
along with systolic and diastolic pressure. The
measurement data will be stored into the selected
user memory.
3. ’ ’ and a number from 1 to 7 will appear if the
measurement was not performed properly. Refer
to the ’Troubleshooting Guide’ section for details
about specific error message numbers and repeat
the measurement.
4. Press the Start/Stop button to shut off the
blood pressure monitor. The device will also shut
off by itself after about one minute.
5. Wait at least five minutes before taking another
measurement.
Bluetooth
®
data transfer
If the Bluetooth
®
function is activated on the
unit, measurement data is transferred to your
paired mobile device after measurement.
The blood pressure monitor will display the
Bluetooth
®
symbol ’ ’ during data transfer.
When connecting for the first time, a randomly-
gene rated six-digit PIN code is displayed on device,
and at the same time an input field appears on the
smartphone in which you must enter this six-digit
PIN code. After successfully entering the code, the
device will be connected to your smartphone. Press
the Start/Stop button again to shut off the blood
pressure monitor.