11
5. Appliance description
1
2
3
4
5
6
1. LLED illumination 4. Battery compartment
2. Mirror (five times magnification) 5. Wall bracket
3. On/Off button (for adjusting the light intensity) 6. Swivel joints
6. Initial use
Wall fastening
• Remove the wall bracket and attach it to the wall using the assembly kit provided (2
screws, 2 wall plugs).
• First mark the desired position on the wall and drill 2 holes at the appropriate intervals.
• Insert the wall plugs. Then attach the wall bracket, by screwing the screws into the wall
plugs.
• Now attach the mirror to the wall by screwing in the screw on the underneath of the wall
bracket.
Inserting the batteries
In order to use the cosmetics mirror, you first need to insert the supplied batteries. To insert
the batteries, follow the steps below:
1. Remove the battery compartment lid on the rear of the device.
2. Insert the three supplied 1.5V AA (alkaline type LR6) batteries. Make sure that the
batteries are inserted with the correct polarity, according to the label. Do not use
rechargeable batteries.
3. Close the battery compartment lid carefully.
7. Usage
• The light can be switched on or off using the on/off switch located on the rear of the mirror.
• The light intensity can be adjusted by pressing the on/off switch again. There are three light intensity levels to choose
from.
The light switches off automatically after 10minutes.
8. Cleaning and maintenance
WARNING
• Switch off the device each time before cleaning.
• First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly moistened cloth. Then wipe it
dry with a soft, lint-free cloth.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device or accessories.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.
1.
2.
1
2
To Next Page
