17
Output
current
max. 90 mApp (1000 ohm)
Voltage
supply
2 x 1.5V AAA battery
Treatment
time
20 minutes, the device then switches off
automatically
Intensity Adjustable from 0 to 15
Operating
conditions
10°C – 40°C (50°F – 104°F) at a relative
humidity of 30 – 85%
Storage con-
ditions
-10°C – 50°C (14°F – 122°F) with a relative
humidity of 10–95%
Dimensions 429 x 125 x 21 mm
Weight 110 g (without batteries),
133 g (with batteries)
Note:
If the device is not used according to the instructions spe-
cified, perfect functionality cannot be guaranteed!
We reserve the right to make technical changes to impro-
ve and develop the product.
7. What if there are problems?
Problem Possible cause/remedy
Device will not
switch on.
- Press and hold down the “
” but-
ton again for 1.5 seconds.
- Check that the batteries are
inserted correctly and try to switch
on the device again.
- The batteries could be flat.
Replace the batteries and try to
switch on the device again.
The gel film no
longer adheres to
the skin.
- Replace the gel film.
The device beeps
unusually during
use.
- Press and hold down the “
”
button for 1.5 seconds to switch
off the device. Then press and
hold down the “
” button for 1.5
seconds to switch on the device
again.
- There is insufficient skin contact
with the gel pads. Replace the gel
pads.
- The batteries could be low and
must be replaced.
To Next Page
Loading...
