15
2. Select the TENS 13 program as described in the "Starting
Application" section, steps 3-5.
3. Use the
˄/˅ setting buttons to select an impulse frequency
and use the ENTER Button to confirm.
4. Use the
˄/˅ setting buttons to select an impulse width and
use the ENTER Button to confirm.
5. Use the
˄/˅ setting buttons to select a treatment time and
use the ENTER Button to confirm.
6. Use the left and right
˄/˅ setting buttons for CH1 and CH2
to select an impulse intensity.
TENS 14
Various impulse sequences run in this burst program. Burst
programs are suitable for all areas of application to be
treated with changing signal patterns (to minimize the level of
accustoming to the treatment). In this program, you can set an
impulse width between 80 and 250 μs.
1. Place the electrodes on the desired area for treatment (for
placement suggestions see the "Electrode Positioning"
section) and connect them to the device.
2. Select the TENS 14 program as described in the "Starting
Application" section, steps 3-5.
3. Use the
˄/˅ setting buttons to select an impulse width and
use the ENTER Button to confirm.
4. Use the
˄/˅ setting buttons to select a treatment time and
use the ENTER Button to confirm.
5. Use the left and right
˄/˅ setting buttons for CH1 and CH2
to select an impulse intensity.
TENS 15
In this program, you can set the impulse frequency between 1
and 150 Hz. The impulse width changes during the stimulation
treatment.
1. Place the electrodes on the desired area for treatment (for
placement suggestions see the "Electrode Positioning"
section) and connect them to the device.
2. Select the TENS 15 program as described in section
"Starting Application" section, steps 3-5.
3. Use the
˄/˅ setting buttons to select an impulse frequency
and use the ENTER Button to confirm.
4. Use the
˄/˅ setting buttons to select a treatment time and
use the ENTER Button to confirm.
5. Use the left and right
˄/˅ setting buttons for CH1 and CH2
to select an impulse intensity.
EMS 33
In this program, you can set the impulse frequency between
1 and 150 Hz and the impulse width between 80 and 320 μs.
1. Place the electrodes on the desired area for treatment (for
placement suggestions see the "Electrode Positioning"
section) and connect them to the device.
2. Select the EMS 33 program as described in the "Starting
Application" section, steps 3-5.
3. Use the
˄/˅ setting buttons to select an impulse frequency
and use the ENTER button to confirm.
4. Use the
˄/˅ setting buttons to select an impulse width and
use the ENTER button to confirm.
5. Use the
˄/˅ setting buttons to select a treatment time and
use the ENTER button to confirm.
6. Use the left and right
˄/˅ setting buttons for CH1 and CH2
to select an impulse intensity.
To Next Page
Loading...
