Beurer FB 65 - Device Description; Use

16
4. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
1
LED touch display
2
Splash protection
3
Fill level mark (max. 5.5 l)
4
Ambient lighting
5
Foot rest with massage nodules
6
Bubble bar
7
Massage roller attachments (6 pieces)
8
Motorised pedicure centre
9
Portable pedicure device
10
Brush attachment
11
Massage attachment
12
ON/OFF button
13
“Increase water temperature” /
“Switch water heating on” function button
14
“Decrease water temperature” /
“Switch water heating o” function button
15
“Vibration” function button
16
“Programs” function button
17
“Bubble” function button
18
“Ambient lighting” function button
19
Water temperature / timer time display
20
“Timer” function button
21
Cable outlet
22
Cord winder
23
Rubber feet
24
Storage / drying bag
5. USE
Initial use
1. Remove the packaging, including the film protecting the display.
2. Check the complete scope of delivery (including packaging) for damage.
3. Before plugging the foot bath in, fill it with cold or warm water up to the fill level mark
3
(approx. 5 cm
high). The foot rest part must be completely submerged under water.
4. Place the foot bath on afirm and level surface.
5. Ensure that the mains cable does not pose atrip hazard.
6.
Insert the mains plug into asuitable socket. The ON/OFF button
12
starts to flash. The foot bath is in
standby mode.
Using the foot bath
1. Sit in acomfortable position. Never use the foot bath standing up.
2.
Place your feet in the foot bath. The rubber feet on the base of the device prevent the foot bath from
slipping.
3.
Press the ON/OFF button
12
to switch the foot bath on. The ON/OFF button
12
lights up and stays lit; the
display
19
shows the current water temperature. The foot bath is now ready for use.
4. The massage is especially eective if you move your feet back and forth over the massage roller attach
-
ments
7
in the foot rest.