Beurer FB 65 - Page 17

17
At the end of use
To switch the foot bath o again before the automatic switch-o takes eect (see “Timer function”), press
the ON/OFF button
12
again. The ON/OFF button
12
flashes again. The foot bath is in standby mode.
Switch the foot bath o after use and remove the mains plug from the socket.
Pedicure attachments
The foot bath has amotorised pedicure centre
8
for individual pedicure.
There are three dierent attachments
9 10 11
that you can attach to the motorised pedicure centre
8
:
• The portable pedicure device attachment
9
can be used to remove dead skin cells and calluses.
• The brush attachment
10
can be used to stimulate the reflex zones in the soles of your feet.
• The massage attachment
11
provides apleasant massage for your feet and stimulates circulation.
We recommend attaching the pedicure attachments when the foot bath is in standby mode.
Setting the water temperature
You can use the foot bath with and without water heating. The water heating can be set to between
34°Cand 48°C. The water heating starts at 34°C. You can increase/decrease the water temperature in
2°Cincrements.
1.
To switch the water heating on, press the “Increase water temperature” / “Switch on water heating” func-
tion button
13
.
2. To increase the water temperature in the foot bath, press the “Increase water temperature” / “Switch on
water heating” function button
13
.
3.
Select your desired water temperature using the “Water temperature / Water heating” function buttons
13
14
. The desired water temperature is shown briefly on the display
19
before the display returns to show-
ing the current water temperature.
4. The heating process starts.
• The foot bath has amemory function that remembers the set water temperature until the
power circuit is interrupted.
• For quicker heating, we recommend activating the “Bubble” function as well.
• Dierent water temperatures have apositive eect on the feeling in your body. Choose the
right water temperature for your wellness experience:
- Cold water (24–29°C– without water heating) has arefreshing and vitalising eect on
the body. It awakens your spirits and brings new energy.
- Lukewarm water (30–40°C) supports an optimal wellness experience and has anurtur
-
ing and constructive eect.
- Warm water (approx. 42–48°C) has aparticularly soothing and warming eect on the
body and, as aresult, can support the immune system. Please note that the water tem
-
perature should increase slowly and should not be set too high initially.
5. To reduce the water temperature in the foot bath, press the “Decrease water temperature” / “Switch o
water heating” function button
14
.
6.
The water heating has been switched o when the LEDs of the “Water temperature / water heating” func-
tion buttons
13 14
turn o.
Vibration massage
You can switch avibration massage on during use.
1. To switch the vibration massage on, press the “Vibration” function button
15
. The LED of function button
15
starts to light up.
2. To switch the vibration massage o again, press function button
15
again. The LED turns o.