Beurer FB 65 - Page 18

18
Automatic programs
The foot bath has one preset and three individually selectable programs:
PO = Manual operation / Program OFF (default)
P1 = Bubble and vibration massage on simultaneously for 10 seconds and pause for 5 seconds
P2 = Bubble massage and pulsating vibration alternating for 15 seconds each
P3 = Bubble and vibration massage alternating for 10 seconds each
1. Select the desired program (P1, P2, P3) using the “Programs” function button
16
. The LED of function
button
16
starts to light up. The currently set program is briefly displayed on the LED touch display
1
.
The display switches back again to the water temperature.
2. To change to manual mode, press function button
16
again until PO appears in the LED touch display
1
. The function button
16
LED turns o.
Bubble massage
You can switch abubble massage on during use.
1. To switch the bubble massage on, press the “Bubble” function button
17
. The LED of function button
17
starts to light up.
2. To switch the bubble massage o again, press function button
17
again. The LED turns o.
Ambient lighting
You can switch ambient lighting on during use.
1. To switch the ambient lighting on, press the “Ambient lighting” function button
18
. The LED of function
button
18
and the light strips in the foot bath begin to light up.
2. Use function button
18
to select the desired ambient light (red, green, blue, yellow, purple or turquoise).
• Red light can increase circulation and stimulate metabolism.
• Green light can have abalancing eect and increase the recovery factor.
• Blue light supports relaxation and can have aharmonising eect.
• Yellow light can generate positive energies and increase optimism.
• Purple light can put the body in an improved meditative mood and be inspiring.
• Turquoise light can have acalming and cooling eect on the body and is particularly recommended
with cold water.
3.
To switch the ambient lighting o, either press and hold function button
18
for two seconds or press
function button
18
repeatedly until the LED of function button
18
and the light strips in the foot bath go
out after the turquoise light.
Timer function
You can set atimer time of between 20 and 60 minutes (in 5-minute increments) on the foot bath. After this
time has passed the foot bath switches o automatically. Initially, the timer time is automatically preset to
20 minutes.
1.
Use the “Timer” function button
20
to select your desired relaxation time. The selected timer time is shown
briefly in the water temperature / timer time display
19
before the water temperature is displayed again.
2. You can display the remaining relaxation time during use by pressing function button
20
once.
3. If function button
20
is pressed several times during use, the relaxation time is restarted.
4. As soon as the relaxation time has elapsed, the foot bath automatically switches to standby mode.