4
• Never fall asleep during radiation!
• Prolonged use can cause burns to the skin.
• Do not touch the infrared lamp or unscrew it when it is connected to the mains.
• Children do not understand the risks associated with electrical appliances. Make sure the appliance inot
used by children without appropriate supervision.
• The appliance may be used only under supervision.
• Keep children away from packaging materials (risk of suffocation).
• Do not cover up or pack away the unit while it is warm.
• Always remove the mains plug and let the unit cool off before you touch it.
• Do not touch the unit with wet hands while it is plugged in; do not allow any water to be sprayed onto the
unit. The unit must be operated only when it is completely dry.
• Protect the unit from strong impacts.
• Do not pull the mains plug from the socket by the cord.
• In the event of a defect or malfunction, switch the device off immediately and disconnect it from the power
supply.
• If the power cord of the device is damaged, it must be replaced by the manufacturer or an authorised
customer service technician in order to avoid hazard.
• Disconnection from the mains supply is only guaranteed if the mains plug has been removed from the socket.
• There is a risk of strangulation for babies and children who become trapped in the mains cable.
General notes
Important
• Product is not suitable for lighting rooms in private homes.
• This unit is not intended for commercial or clinical use, but only for individual, private household use!
• If you have health concerns of any kind, contact your general practitioner!
• Before you use the unit for the first time, remove all packaging materials.
• Lighting is excluded from the warranty.
Repairs
Important
• Do not open the device. Please do not attempt to repair the unit yourself. This could result in serious inju-
ries. Failure to observe this regulation shall void the warranty.
• If you need to have the unit repaired, contact customer service or an authorised dealer.
4. Unit description
6
5
4
1. Light source
2. Lamp shade
3. Base
4. On/Off button + timer button
5. LED timer indication
6. First LED = readiness indicator/standby
To Next Page
Loading...
