Beurer LB 37 - Troubleshooting, Disposal, and Specifications; Problem Resolution and FAQs; Environmental Disposal and Technical Details

9
10. What if there are problems?
Problem Cause Solution
No LED display The mains cable is not plugged in. Connect the plug.
Red LED The water level is too low; the wa
-
ter tank is empty.
Fill the water tank.
No mist is produced The LED display lights red . Fill the water tank.
The LED display does not light up.
The mist has a strange
smell
The device is new. Remove the water tank, turn the screwed plug
and remove it.
Air the open, emply water tank in acool, dry place
for twelve hours.
Stale or dirty water.
Empty the base unit and the water tank and clean
them thoroughly.
Fill the water tank with fresh water.
Strange noise
The water tank is not positioned
correctly on the base unit.
Lift up the water tank and position it correctly on
the base unit.
The tank should sit tightly on the base unit.
There is too little water in the water
tank.
Fill the water tank.
The device is not level and unsta
-
ble.
Place the device on afirm, level surface.
Mist escapes underneath
the water tank
The water tank is not positioned
correctly on the base unit.
Lift up the water tank.
Check whether the join between the base unit
and water tank is clean.
Clean if required.
Position the water tank correctly on the base unit.
The tank should sit tightly on the base unit.
The LED lights up red
although the tank is full
The device evaluates the water
level incorrectly due to a fault.
Restart the device.
11. Disposal
For environmental reasons, do not dispose of the device in the household waste at the end of
its useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste disposal.
12. Technical specifications
Dimensions (LxWxH) approx. 21cm x 11cm x 25,5cm
Cable length approx. 1.5m
Mains voltage/frequency 100 – 240 V AC / 50/60 Hz
Nominal power
max. 20W
Room size up to 20m²
Capacity approx. 2litres
Evaporation output 200ml/hour
Signs and symbols
The unit is double-protected and thus corresponds to protection class 2.
Volume
approx. 35dB