18
6. Operation
Note
Check the humidity of your ambient air regularly. Intensive continuous operation can cause the ambient air
to become excessively humid. The relative air humidity should not exceed 60%.
Switching on the device
1. Plug the mains cable into a suitable socket.
2. Turn the control dial clockwise.. The fill level indicator starts to glow blue. Mist now flows from the mist
outlet. If there is not enough water or no water at all in the water tank, the fill level indicator will light up
red and the device will switch off for safety reasons. Should the device switch off, fill the water tank as
described in the section “Filling the water tank”.
3.
Using the control dial, select the desired evaporation output. Evaporation is limited to a maximum of
300 ml per hour.
Note
You may optionally add drops of aroma/scented oils to the aroma pad in the aroma compartment. This
releases a fragrance into the air. Under no circumstances should you add the aroma directly to the water.
Switching off the device
1. Turn the control dial left as far as it will go, until you feel slight resistance and the control dial clicks. The
fill level indicator goes out.
2. Unplug the mains cable from the mains socket.
7. Cleaning and maintenance
Regular cleaning and disinfection is a prerequisite for hygienic and fault-free operation. The level of
contamination of the device depends on the water quality and how long it has been in operation. In any
case, we recommend the following cleaning intervals.
Every three days As required
x
Cleaning the ultrasound membrane with a cotton bud, rinsing the base
unit
x Rinsing the water tank, replacing the water
x Cleaning the air humidifier inside and out
x Descaling
WARNING
Switch off the device after every use and before cleaning. Pull the plug out of the mains socket.
IMPORTANT
The water tank must be cleaned and the air humidifier completely emptied if the device has not been used
for over a week.
Note
•
C
lean the device using only the methods specified.
•
U
nder no circumstances may water enter the inside of the housing.
•
D
o not use any solvent-based cleaning products.
•
U
se only a mild detergent or vinegar/vinegar-based cleaner to perform cleaning or disinfection work.
To Next Page
Loading...
