EasyManua.ls Logo

Beurer MP 48 - 9� Cleaning and Maintenance; 10� What if There Are Problems; 11� Disposal; 12� Technical Specifications

Beurer MP 48
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
9. Cleaning and maintenance
WARNING
Before beginning cleaning, pull the mains adapter out of the socket!
Carefully clean the bottom of the device interior with a damp cloth after each use�
Do not use any cleaning agents or solvents�
10. What if there are problems?
Problem Possible cause Solution
Nail dryer cannot be
switched on�
Mains adapter not plugged in
Plug the mains adapter into the socket�
Check that the female connector is positioned
correctly
Female connector not inserted
No voltage at mains socket
Check your fusebox�
UV/LED nail gel
does not set�
Set application duration too
short
Set a longer application duration on the nail
dryer� Set the application duration according to
the recommended setting time of the UV/LED
nail gel manufacturer
11. Disposal
For environmental reasons, do not dispose of the device in the household waste at the end of its useful life�
Dispose of the device at a suitable local collection or recycling point� Dispose of the device in ac-
cordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment)�
If you have any questions, please contact the local authorities responsible for waste disposal�
12. Technical specifications
Model MP 48
Dimensions L18�9 x W16�5 x H7�6 cm
Weight approx� 330 g
Power supply 100-240 V~, 50/60 Hz
Light source wavelength range 365 - 395 nm
Device input 24 V 1 A
Voltage supply Input: 100-240 V~, 50-60 Hz, 0�7 A
Output: 24�0 V 1�0 A, 24�0 W
Average active eciency ≥ 87�94 %
No-load power consumption ≤ 0�09 W
Subject to technical changes
13. Warranty / service
Beurer GmbH,Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as “Beurer”) provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not aect the seller’s statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.

Table of Contents

Related product manuals