Beurer MP 58 - Troubleshooting Common Issues; Replacement Parts Information; Product Disposal Guidelines; Beurer MP 58 Technical Specifications

12
6. What if there are problems?
Problem Possible cause Solution
Device will not switch on. Mains plug not plugged in. Insert the mains plug into the socket.
No voltage at mains socket. Check your fusebox.
UV nail gel does not dry. Treatment time with UV light too short. Set a longer UV light treatment time.
Nail varnish does not dry. Treatment time in dryer too short. Keep your varnished nails in the dryer for
longer.
UV fluorescent tube does
not light up.
UV fluorescent tube not correctly in
-
serted.
Check that the UV fluorescent tube has
been correctly inserted.
UV fluorescent tube faulty. Insert a new UV fluorescent tube.
7. Replacement parts and wearing parts
Replacement parts and wearing parts are available from the corresponding service address (according to the service
address list). Please state the corresponding order number.
Designation Item number and/or order number
UV fluorescent tube, 1 unit 163.290
8. Disposal
Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equip-
ment).
If you have any queries, please contact the appropriate local authorities.
9. Technical data
Model no. MP 58
Dimensions L220 x W210 x H100 mm
Weight 1632 g
Power supply 220 – 240 V, ~ 50/60 Hz
Nominal power 40 W
Permissible storage conditions Store in a clean and dry place
Number of UV lamps 4
UV lamp type UV-9 W-L 365 nm, 9 W
UV type of device UV-A lamp type 3
Switch-off times 90 seconds, 120 seconds, continuous operation
Subject to errors and changes