8
To put the device into operation, proceed as follows:
• Remove the packaging.
• Check the device, mains adapter and cable for damage.
• Ensure that the cable does not pose a trip hazard while the device is be-
ing charged.
• Connect the device to the mains. When doing so, the device must be
switched off, with the sliding switch in the middle position. If the red/
green LED above the sliding switch is flashing, this means the device is
switched on, and therefore cannot be charged.
• Charge the device for approximately 3 hours before the first use.
• When the 3 blue charger indicator lights flash continuously, it means the
battery is charging. Once all 3 LEDs are permanently illuminated, the
device is fully charged. You can now begin using the device on battery
power.
• If the blue LEDs flash quickly (1, 2 or 3 LEDs depending on the speed set-
ting) during battery operation, this indicates that the battery is dead.
• You can charge the device by plugging it into the mains, or alternatively
using the USB cable.
• One charge is sufficient for approx. 2 hours of cordless operation.
The device switches off automatically after 20 minutes. After this time,
have a break of at least 15 minutes to prevent the motor from over-
heating.
6. Use
General
– This device is intended for the treatment of hands (manicure) and feet
(pedicure) only.
– Make sure that the device is switched off beforehand.
– Select the desired attachment part and carefully press it onto the axle of
the device. To remove, pull apart the attachment and the device in oppos
-
ing directions.
– Switch on the device by moving the sliding switch down (anti-clockwise
rotation, LED lights up red) or up (clockwise rotation, LED lights up green).
– You can select the speed of the drive axle using the plus (+) and minus
(-) buttons. Start each application at a low speed and then increase as
required.
To Next Page
Loading...
