Beurer SI 40 - Cleaning and Disinfection; Main Unit and Accessory Cleaning; Nozzle Cleaning Procedure; Mask Disinfection with Boiling Water

7
3.
T wist the lid anti-clockwise. Observe the marking
on the lid when you do this. Remove the lid. Empty
any remaining water from the water heater tank.
Then dry it with aclean cloth or let it air-dry com-
pletely. Residual moisture or wetness represents
an increased risk of bacterial growth.
4. Pull out the aroma container/return container.
5. Clean the aroma container/return container, the
cover, the lid, the extension tube and the mask
with warm water and a mild cleaning agent. Clean
these parts thoroughly and allow them to dry com-
pletely. Residual moisture or wetness represents
an increased risk of bacterial growth.
6.
O nce the parts are completely dry, you can reas-
semble the device.
7. Store the device in acool, dry place.
Cleaning the main unit
• Never submerge the main unit in water.
• Clean the main unit using asoft, slightly damp cloth
and amild cleaning agent. Then wipe dry with asoft,
lint-free cloth. Do not use any chemical or abrasive
cleaning agents.
Note
Any other cleaning method or type of cleaning product
could damage the device. Failure to comply with this
instruction will void the warranty.
Cleaning the nozzle
Note
Periodically, the nozzle that directs the steam into ex-
tension tube may become blocked. When the device
starts to produce significantly less steam, or no steam
at all, you need to clean the nozzle.
1.
P ull the cover up and off.
2.
T urn the nozzle in aclockwise direction. Pull the
nozzle up and off.
3.
I nsert athin object (for example aneedle) into the
nozzle in order to clean the air duct.
4. T o reattach the nozzle, align the grips of the noz-
zle with the recesses on the nozzle head. Turn the
nozzle anticlockwise, until you feel the grips of the
nozzle click into place.
Disinfection
The mask can be disinfected using boiling water.
• Remove the mask from extension tube.
• Place the mask into boiling water for 5 minutes.
• Then dry the mask carefully using asoft cloth.
• Re-attach the mask to the extension tube once it has
completely dried.
Storage
• Do not store in damp conditions (such as in abath-
room) and do not transport with any damp items.
• When storing and transporting, protect from pro-
longed direct sunlight.