Beurer SI 40 - Disposal and Troubleshooting; Troubleshooting Common Device Issues; Hygiene Requirement: Separate Masks

8
• Store the device in adry place, ideally in the original
packaging.
7. Disposal
For environmental reasons, do not dispose of the de-
vice in the household waste.
Please dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and
Electronic Equipment).
If you have any questions, please contact the
local authorities responsible for waste disposal.
8. Troubleshooting
Problem/
question
Possible cause/remedy
The ON/
OFF switch
has been
switched
on, but the
device is not
working.
1. Check the power connection to
the socket and check whether
the mains plug has been
plugged in correctly.
2. The device has a thermal fuse.
Following switch-off, the mains
plug must be pulled out and a
waiting period observed (see the
section on fuses in Chapter 3
„Warnings and safety notes“).
The device is
switched on
but produces
no or hardly
any steam.
1. Check that there is water in the
container of the water heater
tank.
2. Check that there is liquid in the
aroma container.
3. Make sure that the suction tube
and other components have
been attached properly.
4. Check the nozzle for blockages.
Clean the nozzle if necessary
(see “Cleaning the nozzle”
section in the “Cleaning and
disinfection” chapter)
Does every
-
one need
aseparate
mask?
Yes, this is absolutely essential for
hygiene reasons.
9. Technical specifications
Model
SI 40
Dimensions
(WxHxD) 265 x 260 x 96 mm
Weight
620 g
Filling volume
of internal water
heater Max. 25 ml
Aroma container
filling volume Max. 60 ml
Mains connection 220 – 240 V~; 50 – 60 Hz
Steam
temperature
Approx. 43°C
Water boiling time
Approx. 2 minutes
Maximum
operation time Approx. 10 minutes
Operating
conditions
Temperature: +10°Cto +40°C
Relative humidity: 10% to 95%
Ambient pressure: 700 hPa to
1060hPa
Storage and
transportation
conditions
Temperature: 0°Cto +60°C
Relative humidity: 10% to 95%
Ambient pressure: 500hPa
to 1060hPa
Subject to technical changes.
Please contact the specified service address to ob-
tain further information, such as the CE Declaration
of Conformity.
10. Replacement parts and
wearing parts
Designation Material REF
Mask PVC 601.34
11. Warranty / service
Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Ger-
many (hereinafter referred to as “Beurer”) provides a
warranty for this product, subject to the requirements
below and to the extent described as follows.