Need help?Do you have a question about the Bewator K42 and is the answer not in the manual?
Configure codes 1 and 2 using jumpers on terminal blocks 8 and 9 for operation.
Disable codes for specific periods by linking terminal block numbers 7/9 or 8/9.
Connect external devices like time clocks or pushbuttons for remote access control.
Set the lock activation duration, variable from 1 to 30 seconds, with a default of 7 seconds.
Enable the keyboard backlight by setting the relevant jumper to the 'ON' position.
Connect failsafe locks to terminal 5 instead of terminal 3 for correct operation.
Details on power voltage, consumption, relay output, temperature range, environment, and dimensions.
To Next Page
General