Aventho wired – Headphones
4
Thank you for choosing Aventho wired headphones. To ensure an optimum listening
experience, we would like to give you a brief instruction on how to use Aventho wired.
For detailed operating instructions, please visit www.beyerdynamic.com/aventho-wired.
Safety instructions
Caution:
When you connect the headphones, please make sure that the volume level is
set to minimum. Adjust the volume level only after putting on the headphones.
We would like to point out that excessively high volumes and long listening times
may cause hearing damage. Hearing defects always constitute an irreversible impairment
of hearing ability.
Always ensure an adequate volume level. It is advisable to keep listening times as short
as possible at high volume levels. According to the Occupational Health and Safety
Regulations of German trade associations BGV B3, noise pollution e.g. in the workplace
must not exceed 85 dB (room volume level) during a maximum permissible listening
time of 8 hours. If the volume level is increased by 3 dB respectively, the permissible
listening time is cut in half, i.e. at 88 dB, the listening time is 4 hours, at 91 dB
2 hours, etc.
Danger to life!
Headphones drastically reduce perception of external sounds. Using headphones in road
traffic can be potentially dangerous. The user’s hearing must not be impaired to the
extent that it causes road safety risks. Please also make sure that you do not use the
in-ear headphones within an area of potentially dangerous machines and tools.
Risk of injury!
Avoid sudden movements when using wired headphones. You might seriously hurt
yourself especially if you wear piercings, earrings, glasses, etc., where the wire can get
caught.
Box contents
• Aventho wired headphones
• Jack connection audio cable 3.5 mm with remote control
• Textile bag
• Warranty booklet
• This Quick Start Guide
To Next Page
Loading...
