How to fix no sound on Beyerdynamic MCS 50 Conference System microphone units?
If there is no sound when the microphone units are switched on, there might be several reasons. The input could be switched off; use the MCS-Editor to switch on the input in the configuration. The gain might be too low on the selected input; use the buttons of the MCS 50 to increase the level of the concerning input amplifier. Also, the input might be overloaded.
What to do if all Beyerdynamic MCS 50 Conference System microphone units are flashing?
If all microphone units are flashing, it indicates that the microphone units have the same address. Check the address of the microphone units to resolve this issue.
Why is the Beyerdynamic Conference System connection to PC not set up?
If the connection to the PC is not set up, it could be due to a defective cable. Try connecting a new cable. Alternatively, the wrong interface may have been configured in the MCS-Editor; use the MCS-Editor to configure a new interface.
How to restore chairman unit functionality on Beyerdynamic MCS 50 Conference System after reset?
If the chairman unit does not work after a reset, the chairman definition is likely missing. Configure the chairman microphone unit with the MCS-Editor.
What to do if not more than 5 microphones are working on Beyerdynamic Conference System?
If there are not more than 5 microphones working, hotplugging may have destroyed the data bus driver. Contact the service or your dealer.
Details on various input and output connectors, including XLR and Sub-D interfaces.
Specifications for power supply units, voltage outputs, and consumption.
Details on frequency response, THD, and audio control parameters.
General| Brand | Beyerdynamic |
|---|---|
| Model | MCS 50 |
| Category | Conference System |
| Language | English |
To Next Page
