Programming the phone numbers
To programme a set of telephone numbers under the disarm mode, assuming the phone number is
“123456789” as an example:
1 Press * 1 1 2 3 4 5 6 7 8 9 * to store the 1
st
telephone number ;
2 Press * 2 1 2 3 4 5 6 7 8 9 * to store the 2
nd
telephone number ;
3 Press * 3 1 2 3 4 5 6 7 8 9 * to store the 3
rd
telephone number ;
4 The green LED will flash 3 times to indicate that the numbers have been stored correctly.
A total of 3 sets of telephone numbers with a maximum of 17 digits can be programmed.
To delete the stored numbers, press * 1 * ; * 2 * ; * 3 * ; the green LED will flash 3
times to indicate that the numbers have been deleted.
To disable the siren (the alarm will have no siren when it’s triggered) :
1 Under disarm mode, press * 7 * ;
2 One “beep” will be sounded.
To reactivate the siren (the siren will be resumed when the alarm is triggered) :
1 Under disarm mode, press Learn button * 7 * ;
2 Two “beep” will be sounded.
Activating / Deactivating SMS function
To deactivate SMS function (the alarm will not send SMS but dial when it’s triggered) :
1 Under disarm mode, press Learn button # 9 # ;
2 One “beep” will be sounded.
To reactivate SMS function (the alarm will send SMS and dial when it’s triggered) :
1 Under disarm mode, press Learn button # 9 # ;
2 Two “beep” will be sounded.
Low battery, need to replace battery
Green LED flashes 3 times
Current operation is completed
Green LED flashes in every 3 seconds
GSM network is accessed with strong signal
Yellow LED flashes in every 3 seconds
Weak network access signal
Error occurs (Data entry is incorrect)
SMS Alert for low battery, when you got the sms alert ,then if the unit be triggered , it
could siren ,but cannot make phone call and send sms, when the Red LED is on ,the
unit completely cannot work .
To Next Page
Loading...