BFT LIBRA - Page 5

14 - LIBRA - Ver. 06
D811323_06
+
OK
Fig. A
OK
Press the OK key
BFT
LIBRA1.0
0000
0000
00
PARAM
LOGIC.
OK
+ / -
+ / -
OK
ACCESS TO MENUS
FOLLOWING MENUS
FIG. B
OK
8 8 8 8
-
+
-
+
Control unit software version
No. total manoeuvres
(in thousands)
No. manoeuvres since latest
maintenance(in thousands)
No. radio control devices
memorised
LEGENDA
[ 00 ] Preset value
Parameter increment/reduction
or ON/OFF commutation
Menu scrolling
(+ = preceding - = following)
Press OK key (Enter/confirm)
Message: Programming in progress
PRG
OK
+ / -
-
+
/ON
/OFF
Message: KO! (value or function error)
Simultaneously press the + and - keys.
Simultaneous pressure of the + and Ð keys
allows you to exit the active menu and return
to the preceding menu; if this takes place at
the main menu level, programming is exited
and the display switched off.
The modifications made are only confirmed if
the OK key is subsequently pressed.
+ / -
END
+ / -
END
Message: ÒWaitÓ (enter value or function)
OK OK
TCA
[ 0010 ]
PRG
OK OK
[ 0050 ]
PRG
Mot1 torque
OK OK
[ 0050 ]
PRG
Mot2 torque
OK OK
[ 0010 ]
PRG
open delay time
OK OK
cls delay time
[ 0010 ]
PRG
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
OK OK
ZONE
[ 0000 ]
PRG
OK
TCA
ON
OFF
[ oFF ]
OK
PRG
OK
3 step
ON
OFF
[ off ]
OK
PRG
OK
ibl open
ON
OFF
[ off ]
OK
PRG
OK
fast cls
ON
OFF
[ off ]
OK
PRG
OK
Fotoc. open
ON
OFF
[ off ]
OK
PRG
OK
TEST PHOT
ON
OFF
[ off ]
OK
PRG
OK
signaling outp
ON
OFF
[ off ]
OK
PRG
OK
i Mot ON
ON
OFF
[ off ]
OK
PRG
OK
BLOC persit
ON
OFF
[ off ]
OK
PRG
OK
Master
ON
OFF
[ off ]
OK
PRG
OK
loop
ON
OFF
[ off ]
OK
PRG
PARAMETER MENU
TCA (automatic closing time)
value expressed in seconds
(default 10=10s, min 3=3s, max 60=60s)
Motor 1 torque value expressed in %
(default 50%, min 1%, max 99%)
Motor 2 torque value expressed in %
(default 50%, min 1%, max 99%)
Opening phase-difference Time
value expressed in tenths of a second
(default 10=1s, min 10=1s, max 50=5s)
Closing phase-difference Time
value expressed in tenths of a second
(default 10=1s, min 10=1s, max 50=5s)
Zone numerical value
(default 0, min 0, max 127)