What to do if BFT LUX not opening during power cut?
In case of a power cut, you can manually release the BFT Gate Opener by inserting the key 'C' (used to adjust the bypass valve) into the triangular pivot 'P' under the actuator and turning it anti-clockwise.
What to do if BFT LUX Gate Opener not restoring to electrical operation after manual opening?
To restore the BFT Gate Opener to electrical operation after manual opening, turn the key clockwise until pivot 'P' is locked.
What to do if I notice malfunctions in BFT Gate Opener automation?
Any malfunction in BFT Gate Opener automation should be corrected immediately by a qualified specialist.
Why does the BFT Gate Opener actuator stop, even though it does not have electric limit switches?
The motors stop when the working time set in the control unit has expired. To resolve this, increase the set time by 2-5 seconds with respect to the time in which the leaves reach the ground gate stops.
Crucial safety guidelines for safe operation, installation, and maintenance to prevent injury.
Provides general safety rules and precautions for using the automated system to avoid accidents.
Instructions on how to manually open the gate in emergency situations like power cuts.
Essential safety instructions for installation, covering hazards and proper procedures.
General safety advice and precautions to be observed during installation and use.
Guidelines for the proper disposal of discarded equipment and batteries according to regulations.
Steps to follow when dismantling the automated system for relocation or servicing.
Conditions and prerequisites for installing the gate operator correctly and safely.
Specific installation guidelines for gate openers with hold-to-run control systems.
Instructions for installing sensors for contact-free detection systems on gate openers.
Guidelines for installing contact detection sensors like rubber edges on gate openers.
Critical safety precautions to minimize the risk of injury or death during operation.
Overview of the product, its class, and general information about the oleodynamic piston.
Identifies and describes the primary components of the gate automation system.
Details the electrical and mechanical specifications, including power, motor, and dimensions.
Comprehensive guide on installing the actuator, covering preliminary checks, installation values, reading dimensions, off-standard setups, and bracket mounting.
Guidance on installing ground gate stops for correct operation of the controller and actuator.
General| Max Gate Weight | 800 kg |
|---|---|
| Max Gate Length | 5 m |
| Operating Temperature | -20°C to +55°C |
| Power Consumption | 150 W |
| Opening Speed | 12 s |
| Safety Features | Obstacle detection |
| Motor Voltage | 230V |
To Next Page
