To Next PageTo Next Page
Need help?Do you have a question about the BFT SUB and is the answer not in the manual?
General| Brand | BFT |
|---|---|
| Model | SUB |
| Category | Gate Opener |
| Language | English |
Manufacturer details and product compliance with Machinery Directive.
Details the SUB hydraulic actuator's design, hidden installation, safety features, and control.
Lists the motor, pump, distributor, and jack; notes left/right identification.
Describes optional foundation cases (CPS, CID) and slide arm (BSC).
Procedure for manually opening the gate in case of power failure.
Ensuring safety device efficiency, handling malfunctions, and keeping children safe.
Recommends oil replacement every two years and checking safety devices.
Guidelines for disposing of automation components according to regulations.
Steps for safely disconnecting and removing components for reassembly.
Actions to take for unresolved malfunctions, contacting qualified personnel.
Warnings about improper use, keeping instructions, safety regulations, and company responsibility.
Connecting mains supply, differential switch, earthing, and safety devices.
Details electrical supply, motor specs, torque, and physical dimensions.
Ensuring gate structure is sturdy, hinges are functional, and preparation for installation.
Detailed instructions for cementing the foundation case around the actuator.
Procedure for side installation using a slide arm, including alignment.
Explains the advantages of the CPS case for maintenance and operation.
Steps for preparing the leaf shoe and aligning the actuator shaft for connection.
Procedure for setting the actuator without slow-down function, including alignment.
Procedure for setting the actuator with slow-down function, including angle adjustments.
Instructions for adjusting the slow-down speed using adjustment screws.
Requirement for ground stop plates on opening and closing for safety.
Adjusting the trimmer for the delayed leaf's phase difference during closing.
Instructions for fitting the EBP model electric lock for gate closing.
Adjusting pushing force using 'open' and 'close' by-pass valves for antisquash safety.
Describes different control types (manual, radio, access control) and user instruction.
Checking oil level and bleeding air from the hydraulic circuit.
States the constant aerial noise level does not exceed 70 dB(A).
Steps to resolve when the gate does not open and the motor is not turning.
Steps to resolve when the gate does not open and the actuator vibrates without movement.
