Press P1 on the
transmitter to be
cancelled
(see fig. 1A)
Red
Press T1,T2,T3 or T4
to be cancelled from
QTELEC memory
(see fig. 2A)
Cancellation
of START
on memorised
transmitters
Press SW1
on control unit
Press T1,T2,T3 or T4
to be cancelled from
QTELEC memory
(see fig. 2A)
To cancel another T key from the transmitter itself or another transmitter
Key T on the
transmitter,
memorised as
[START]
is cancelled
from QTELEC
memory
2nd CHANNEL
cancellation
on memorised
transmitters
Simultaneously press SW1 and
SW2 for 10 seconds on Qtelec
control unit
Red Off
Green On, emits 1 blink
All memorised transmitters are cancelled
and all QTELEC parameters modified.
Only parameters set by manufacturer
are left and specified in paragraphs
“Function logic settings” between
square brackets [ ].
Total cancellation of QTELEC
transmitter memory and
modifications
(only data set by
manufacturerleft)
Green
Alternate blinking
Green-Red
Alternate blinking
Green-Red
Red Off
1
1
1
1
1
1
1
1
1
1
SW1
SW2
Simultaneously press
control unit keys
SW1 and SW2
3 times and release
SW1
SW2
SW1
SW2
1
2
Menu C Menu C - QTELEC CONTROL UNIT MEMORY CANCELLATION
Alternate blinking
Green-Red
1
1
1
1
SW1
SW2
3
Wait for 60s
to exit
programming
or disconnect
supply
Key T on the
transmitter,
memorised as
[2 CHANNEL]
is cancelled
from QTELEC
memory
Wait for 60s
to exit
programming
or disconnect
supply
Menu A
SW1
OFF
Open jumper
J1
at the end
of programming
Menu B
Green On emits
1 blink
To Next Page
Loading...
Need help?
General
