-
Keep out of animal and children’s reach.
-
When unplugging the cable from the outlet, do not pull the cable, pull the plug. Always pull the
charger’s cable smoothly.
-
Do not use outlets, connectors or other electrical systems with different voltages than the standard.
-
Do not use damaged components, such as the chargers casing, cable or pin; if the cable is
damaged it must be
replaced by the manufacturer or your distributor.
MOTOR
The motor meets the most strict quality requirements and is guaranteed for years of reliability. It is a direct
current motor
which is incorporated to the front wheel’s bushing and is capable of developing
250 W (500 W in the Nitro
Models) with a tested energy efficiency higher than 80%. It is a very
compact unit featuring a weight of only 2.5 kg.
It operates without any friction thanks to its Brushless
technology.
As any other part of your bicycle, the useful life of the motor depends on its use. In normal conditions,
the motor may
be useful for 10 or 20 years, or 100,000 km.
The motor emits a certain level of noise during its use. This is normal and it depends on the
demand
BASIC REPAIRS
Replacement of the rear wheel with the RDS system / disconnection of the motor cable
To replace the back wheel you must disconnect the cable from the joint located behind the rear chain
stay (1). Unscrew the nut and also remove the rear washer, taking care to leave the opening of the
black tube facing downwards (2). Unscrew the nut on the left side (3), as well as the safety clamp, to be
able to remove it (4). You can now take off the wheel, replace it with a new one, and then repeat the
process in reverse.
To Next Page
