Bialetti Mukka Express - How to Clean Aerator; How to Hold the Aerator Correctly; Removing the Aerator; Assembling the Aerator

A1
HOW TO HOLD THE AERATOR CORRECTLY:
hold the Aerator by its side "flaps" and avoid putting any
pressure on the button and on the safety ring A1. Fig. 22 a/b
HOW TO CLEAN AERATOR
(cleaning recommended after each use)
REMOVING THE AERATOR
Please refer to the symbols indicated on the bottom of the upper part (0 1)
ASSEMBLING THE AERATOR
9
ALWAYS MAKE SURE THAT THE PRESSURE VALVE IS SECURELY ATTACHED. WHEN YOU
TURN IT COUNTER CLOCKWISE IT MUST NOT COME OFF.
Fig. 22a
Fig. 22b
Fig. 24 Fig. 25Fig. 23
Fig. 27
Fig. 26
1
Pull the safety ring upwards as shown in the figure 23. Turn the
pressure valve counter clockwise from position "1" (Fig. 24) to
position "0" (Fig. 25), keeping the safety ring raised.
Remove the aerator pulling it upwards as shown in the figure 26
and wash it under water as shown in the figure 27.
Figure 23/ 24/ 25/ 26/ 27
Please refer to the symbols indicated on the bottom of the upper part (0 1)
Pull the safety ring upwards (Fig. 27). Insert the aerator on the
column and align to position "0" (Fig. 28).
Push it down until it fits properly on the column making sure it is
still aligned with position "0". Avoid putting any pressure on the
button and the safety ring. (Fig. 29). Turn the pressure valve
clockwise, from position 0 (Fig. 29) to position 1 (Fig. 30). Lower
the safety ring as shown in figure 31 (the ring may have gone
down automatically).
1
Fig. 27 Fig. 28 Fig. 29 Fig. 30
Figure 27/ 28/ 29/ 30/ 31
Fig. 31
If the safety ring does not lower, check and make sure that the aerator is positioned correctly. If the aerator is
positioned correctly and the safety ring still does not lower, the aerator may need to be checked or replaced.