page 10 Installation and Operation Guide Qt X Sound Masking System
Rack Mount installations
Hardware to attach the controller to the rack is not supplied. The unit will not
rotate forward when attached to the rack ears so input/output and speaker
connections should be made prior to attaching it to the rack.
1. Make all emitter, network and audio connections as required in Wiring &
Connections.
2. Plug the power supply into your power source and then into the back of the
controller. The front LCD panel will light up and you can review basic unit
information and operation by navigating through the menu.
3. Secure the Qt X device to the rack via the rack ears as shown in Figure 6.
Figure 6. Attach the controller to the rack
To Next Page
Loading...
Need help?
General
