Instruction manual
(Developed by BIBOTING,All Right Reserved)
•
Ensure your chest is completely clean.
•
Apply essence oil first and then apply
to cream.
•
Apply oil and cream from upper chest
to lower chest and all around breast
area completely.
•
Connect with instrument and blood
circulation cups. Press the power
button.
•
Lean the body slightly forward
then covers the breasts with
both blood circulation cups.
•
Adjust the strength with the airflow
adjuster.(clockwise to strengthen the
power, anticlockwise to lower the power)
•
Please start with a lower strength
until you feel comfortable.(Generally
the stronger, the more effective,
however do not exceed your limit)
•
Machine will stop when time is up.
•
Un-plug the power cord when idle.
•
The power button can be reopened
to continue to use
•
Pull the safety air releaser to remove
the blood circulation cups.
• Turn off the power to remove in emergency
Product fault elimination
· Check the power for securely
plugged into the power point.
· Check the shor t and long tubes
are connected to the right position,
and the airflow adjuster is set to
level 5.
· Adjust your strength from small to
large for the first time using, your
strength can’t be overstrain in
order to avoid any uncomfortable
feeling.
Step 1
Step 3
Step 5
Step 2
Step 4
9
A. Vigour Circulation Cup
Please use cleaning solution or disinfection ethanol first, and fiber towel
secondly to scrub the cup inside and outside (do not use tissue or cotton
towel) after using the product, if the black staleness rubber pin inside is
fallen off, use cotton swab with ethanol to clean the part, and then install
it to the original place.
Caution：Physical contact cup products must be cleaned and disinfected
after using to avoid cross-infection of skin, and personal hygiene products
is not recommended to be cross-used.
Product Maintenance and Storage
Storage
(Developed by BIBOTING,All Right Reserved)
• Store on a flat surface when operating, do not put on any towels.
• Store in a dry area after use, avoid a wet environment and physical damage.
Place the power cord on the side of machine, metal from the power point
may damage the machine, avoid contact.
•
Parts (Vibration cups, small cups, DC cord, airflow adjuster and tubes),
please store in a dry area when not using. Do not use ultraviolet rays
or high temperature steam to clean the parts.
B. Small size cups
Wipe clean with diluted alcohol.(same as above)
C. DC power cord
If the cord is stained by essence oil or cream, un-plug the cord first then
wipe clean with diluted alcohol on fibre towel. To avoid damage to the
cord, please don’t fold the cord.
D. Airflow adjuster
Set the level to 0 and place into hot water for at least 5 mins, and then
clean with cold water and leave it until dry.
E. Long(180CM)/Short tubes(40CM)
Wipe clean with diluted alcohol and fibre towel.
· Caution: Ensure hands are clean before touching the machine panel
and button. Touching the essential oil or frost will influence life and
operation of machine.
10
Parts cleaning
(Developed by BIBOTING,All Right Reserved)
To Next Page
Loading...
