TROUBLESHOOTING
Problem Possible cause Fault correction
The motor
does not run
The overload protection has
responded
Press the reset button, keep the
on/off switch pressed to switch
on the shredder on after a short
period
Power failure
Check the power supply cord, the
plug and the house fuse
The material
to be
chopped is
not pulled in
The material is jammed in the
feed inlet
Disconnect the supply and open
the hopper, pull the material from
the feed inlet. Re-place the hopper
The cutting blade is blocked
Disconnect the supply and open
the hopper, and open the blade
cover, remove the block material,
re-place the blade cover and
hopper
The discharge chute is blocked
Disconnect the supply and open
the hopper, open the plate of the
discharge chute and clear the
jammed material
ENVIRONMENTAL
PROTECTION
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice.
For further information visit www.recycle-
more.co.uk
To Next Page
Loading...