GENERAL MAINTENANCE
1. Tractor and rotary cutter must be shut off (disengaged from any power)
before any acts of maintenance are performed.
2. Check oil level in gearbox periodically. Keep level up to check plug. Use
SAE 90 or SAE 140 transmission oil. Use caution not to over fill.
3. Lubricate universal joint on PTO shaft every few hours of use. Keep PTO
shaft free of dirt and foreign materials so that it will telescope freely to
avoid damage to your tractor or rotary cutter.
4. Lubricate tailwheel.
5. Keep blades sharp. When replacing worn blades, be sure to replace in
pairs to maintain rotary balance.
6. Keep all bolts tightened properly.
WARRANTY
We warrant each new Big Bee Rotary Cutter against defect in material or
workmanship for a period of 90 days or a reasonable period of time dependent
upon the type of use of the machine.
In the event that it is necessary to replace or repair any part(s) during the
warranty period, go to your dealer with the defective part(s) and they will assist
you in obtaining the needed replacement and/or return the defective part(s) to:
DHE Warranty Division
PO Box 140
819 4
th
Street NW
Red Bay, AL 35582
Neither manufacturer or the dealer shall be held responsible for the loss of use of
the machine, loss of time, inconvenience, commercial loss, or consequential
damages.
In order for your Big Bee Rotary Cutter to be covered by our warranty policy, the
equipment registration form on the back cover must be completed and
returned within 10 days after the purchase date.
The warranty policy is not effective unless the equipment registration is recorded
in our office.
To Next Page
Loading...