Shenzhen BIGTREE technology co., LTD.
BIG TREE TECH
communication baud rate 115200
Support file format: G-code
Recommended software: Cura, Simplify3D, pronterface, Repetier-host,
Makerware
Ⅱ. Description of motherboard indicators
After power on the main board:
3.3v red light is power indicator: the red light is on, indicating normal
power supply;
Status red light is the Status indicator: when updating the firmware, it
will flicker.
D8 green light is the HB status indicator for the hot bed: it is always on
when heated, and it goes out when not heated.
D6 green light is the indicator light of E0 status of the heating tube: it is
always on when heating, and it will go out when not heating.
D10 green light for CNC fan FAN0 status indicator: it lights up when
turned on, and goes out when turned off.
D7 green light for CNC fan FAN1 status indicator: it lights up when
turned on, and goes out when turned off.
To Next Page
Loading...
