- EN 6 -
6.2.
Returning to a preset station
• When radio mode is on, press Programme [9] to select the desired preset station number, e.g. P01,
P02, etc. to P20. The display will then show the station number (P01, P02, etc. to P20) and the FM
frequency 3 seconds after the station is selected.
6.3. Scanning
• In radio mode, press Scan [9] for 2 seconds to activate SCAN mode.
• The radio will automatically scan the frequency and save the preset station to memory, with a total of
up to 20 different radio stations. Once SCAN finishes scanning and stops automatically, it will return
to preset station no. P01. The display will show the current time and FM frequency.
When the SCAN function is activated, the newly found stations will replace the preset stations
that have been previously stored in the memory.
7. Volume control
• When the radio is on, press Volume - /+ [2] [3] to increase or decrease the sound volume level.
• The display will show the volume level, 00 ~ 15, from minimum to maximum sound level.
8. Sleep mode timer
• Radio will turn off after the selected time. In Radio mode, press [4] to activate sleep mode.
• It will start to count down from the default 120 minutes. There are options for the user: 120, 90, 60,
30, 15, 10, 05 & OFF. To turn off the sleep mode timer, select OFF.
9. Replace clock back-up batteries
• Insert 2 AAA batteries. Check the polarity (+ and – at ends of the battery) and follow the instructions
on the diagram near the battery compartment. Close the compartment door.
NOTE: Please make sure you properly dispose of batteries (see your local regulations).
10.
Basic specifications:
Output: 0.5W
FM range: 88.8 ~ 108 MHz
AC 100 - 240V ~ 50 / 60 Hz AC adaptor supplied
Battery: 2 X AAA UM4 (R6)
To Next Page
Loading...
