10
Stopping
Stop the truck as gradually as possible.
Unnecessary rapid stopping could be
hazardous. Load could become unsta-
ble.
To stop the truck’s movement (forward
or reverse), raise the control handle to
the up position or push the control han-
dle all the way down. In both positions,
the brake will apply. To release the
brake, just move the control handle to
the operating position.
NOTE: The steering arm gas spring
automatically raises the steer-
ing arm to the upright position
when the steering arm is
released.
CAUTION: If the control handle does
not raise immediately to
the vertical position when
released, the truck should
be placed “OUT OF SER-
VICE” until it can be
inspected by a qualified
service technician.
Parking
When parking the truck, do not obstruct
traffic lanes or aisles.
1. Park the truck in its designated
parking area.
2. Raise the steering arm until vertical
to apply the parking brake.
3. Fully lower forks.
4. Remove the key from the keyhole.
5. On the E25 push the red discon-
nect plunger to remove all power
from the truck circuits.
Steering Arm Braking Positions
To Next Page
Loading...