BigJoe E25 - Operator Checks

6
Operator Checks
ITEM PROCEDURE
Transmission and hydraulic
systems
Check for signs of fluid leakage and/or abnor-
mal noise.
Forks and Frame Check for cracks and damage.
Guards and load backrest Check that safety guards are properly secured
and not damaged.
Safety signs Check that warning labels, nameplate, etc.,
are in good condition and legible.
Horn Check that horn sounds when operated.
Steering Check for binding or looseness in steering
arm when steering.
Tiller switch/Parking brake Check that steering arm raises to upright posi-
tion when released and brake applies.
Brakes Check that brakes actuate when steering arm
is raised to upright position, and when lowered
to horizontal position.
Travel controls Check that speed controls on control handle
operate in all speed ranges in forward and
reverse and that belly button switch functions.
Wheels Check drive wheel for cracks or damage.
Move truck to check load wheels for freedom
of rotation.
Hydraulic controls Check operation of lift and lower to their maxi-
mum positions. Check the oil levels.
Electrical Check that there are no damage to the cables
on the truck and that the horn and lift buttons
work.
Battery disconnect Check that battery can be disconnected and
reconnected. Check for connector damage.