1. Apply a small amount of grease to the lower portion of the post.
2. Open the cam lever on seat collar.
3. Slide the post into the desired height (seat posts have a minimum
insertion level marked on it, make sure this line is completely
hidden within the frame)
4. Close the cam lever (this is tight when it has resistance at mid-
point then close all the way).
Your Battery may ship separately due to logistical and regulatory requirements.
❖ To install the battery make sure the battery is correctly on the slide rail then slide it in & lock.
❖ To remove the battery, insert the key into the lock on the front left side of the battery, turn the key,
slide the battery forward, then lift out.
To Next Page
Loading...