Battery Display
On the top front, there is a battery level display button. When pushed in, the
LED lights below it will glow, indicating the battery level. However, while riding
your bike you must rely on your battery level on the display which is more
accurate.
Charging your Battery
• Do not wait for the battery to fully discharge before charging.
• The charging port is in the battery, so it can be charged on or off the
bike
• Plug your charger into the wall first, lift the rubber cap and then plug in
your charger to the battery
• While charging, the charger will display a red light and green when fully charged
• Properly close the rubber cap before reusing your bike.
• If the battery is in storage you must charge every two months
• Avoid charging immediately after a demanding ride to prevent excessive heat that can increase wear on
the cells of the battery
• Don’t leave the battery on the charger for extended periods after it has charged. The charger and BMS
will protect from overcharging however the charger is not made for the trickle charging that can occur
when left connected
MAINTENANCE & STORAGE
• Always store the battery in temperatures between 5°C (41°F) and 40°C (104°F)
• The battery can be used in temperatures from -20°C (-4°F) to 45°C (113°F)
• Low temperature reduces capacity drastically ~50% range at -40°C (-40°F)
• Disconnect the battery from the bike for extended storage
• Maintain correct tire pressure for your tires and terrain, low tire pressure can reduce efficiency & range
Important: Your bike will arrive with the battery partially charged. You need to give it a full charge before
use. Just charge and go... then just top your battery up after each use (lithium batteries prefer shallow
discharge). Give your battery a complete discharge and full charge every 3 months or so to keep the cells
well balanced.
To Next Page
Loading...