(A) Thru-Axle Wheel
(1) (2)
1. To install the wheel you must first remove the Thru-axle from the fork.
• With a 6mm hex key unthread the axle bolt from the drive side of the bike.
• Now push the long thru-axle through to the non-drive side and pull it out.
2. Grab the wheel and insert between fork dropouts taking care not to scratch the brake pads.
• Push the thru-axle from the non-drive side, through the dropouts and hub, towards the drive side.
• Now thread the axle bolt into the thru-axle.
• Tighten on both sides with a 6mm hex key.
Prot Tip: If you find it difficult to slide-out or slide-in the thru-axle DO NOT hammer the axle!
Loosen the 2 bolts at the bottom of each fork leg as shown in Pic-2 with White Arrows.
To Next Page
Loading...