– New hose sets supplied with the appliance
are to be used. Old hose sets should not
be re-used.
– Billi hose sets as supplied with the appliance
are to be used. Old or other manufacturer’s
hose sets should not be re-used.
– If the appliance is located where the
ambient air temperature could fall below
4°C when the heater is not in use, do not
turn o the power supply to the appliance.
This safeguard does not oer the same
protection to the connecting pipework
and fittings.
– The ambient temperatures this unit should
operate within are 4°C to 45°C.
– Turn o power to unit, by unplugging
the power cord from the power point,
if water supply is turned o
Caution and safety
Boiling water is dangerous and can cause
severe burns, particularly with young children.
Boiling water must always be handled with
caution. Use this appliance only as directed
in these instructions and only for the purpose
for which it has been designed. Your Billi
Alpine is designed to be safe and practical.
In an environment with young children,
it is recommended that the boiling water
safety switch is activated.
The following safety features have been
included:
– Ergonomic levers, or sensitive touch
panel control water flow
– Levers/touch activations located safely
above water outlet.
– Smooth electronically controlled boiling
water flow rate. Flow is briefly reduced as
water first enters cup to prevent splashing
.
– Dispenser remains cool to touch.
– Childproof safety switch.
– Boiling water Safety Isolation mode.
General Maintenance
Your Billi Alpine has been designed to require
minimal maintenance other than replacement
of filter cartridges. During each filter change,
check all water connection fittings for signs
of leakage. Check all tubing for any signs of
damage. Check the cupboard area around
the base of unit for any signs of moisture.
Ensure side vents of the under bench module
are kept clear and airflow is not obstructed.
Restricted airflow will cause inecient
operation of the refrigeration system.
—Cleaning the dispenser
Your Billi Alpine Dispenser is fabricated
from robust metal with a tough protect
chrome plating. Care of dispenser is as
with any chrome plated tapware. Avoid using
abrasive cleaners. Wipe clean using a damp
cloth. Use of a non-solvent, non-smearing
cleaner such as Windex is recommended.
Do not pour water over dispenser.
Cupboard ventilation requirements
Your Billi Alpine underbench module requires
no cupboard ventilation but requires air space
around the unit of 25mm. Care should be
taken when using the cupboard space,
to avoid stretching or damaging plastic
pipe work. Check fittings and tubing at each
filter change for signs of damage or leakage.
Always ensure access to power switch
and water supply tap is not restricted.
3
User guide
Billi Alpine.
To Next Page
Loading...
