Billi Alpine - Features and Modes; Dispenser Swivel; Billi Alpine 125 Dual Temp Dispenser; Adjustable Chilled Water Temperature

User guide
Billi Alpine.
Features and Modes
—Dispenser Swivel
The Alpine dispenser incorporates a swivel
function, allowing the dispenser to be swung
out of the way if more sink space is required.
A central position stop provides positive
location during normal usage.
—Billi Alpine 125 Dual Temp Dispenser
The Billi Alpine 125 dispenses both chilled
and ambient filtered water. This system
will never run out of filtered water.
—Adjustable chilled water temperature
The chilled water delivery temperature can
be adjusted to suit your preference. The blue
control knob, located on the front of the Chiller
Module, can be adjusted if a cooler or warmer
temperature is required.
—Safety Timeout
Your Billi Alpine incorporates a water delivery
Safety Timeout to prevent an uncontrolled flow
of water. Water flow stops automatically after
a set time interval. Flow can be started again
by releasing and pressing the dispenser lever.
Chilled water timeout – 1 minute;
Ambient water timeout – 1 minute
—Holiday mode (Alpine 125 Only)
Holiday Mode is provided to save energy
when the unit will not be used for long periods.
In this mode both the water chiller and water
heater are disabled and the unit will use very
little power. Pressing the Pressure Relief
button places the unit in Holiday Mode.
The unit will exit Holiday Mode if either the
power is turned o then on or if any of the
tap levers are pressed
. The Self Learning
Timer will ignore user behaviour while the
unit is in Holiday Mode and resume normal
operation when the mode is terminated.
Holiday Mode is indicated by the moon
& star icons.
—Standby Mode (Alpine 125 Only)
Standby operation may be optionally
enabled to reduce power consumption.
In standby mode the cold water set point
is increased to 18°C. When enabled, standby
is invoked after two hours from the time
of last use. When a tap lever is pressed in
standby no water is dispensed. The indicators
will flash to indicate the water is not ready.
The tap lever can be repressed to dispense
water. To activate, refer to Options.
4