What to do if Billy Goat Vacuum Cleaner nozzle scrapes the ground?
If the nozzle of your Billy Goat Vacuum Cleaner scrapes the ground even at the highest setting, it's likely that the nozzle height is out of adjustment. Adjust the nozzle height.
Why Billy Goat Blower is not self-propelling?
If your Billy Goat Blower isn't self-propelling, the drive bail may not be engaged. Check the drive belt for wear or breakage. Also, inspect the drive clutch cable for proper adjustment or breakage and check if the drive chain is off the sprocket. Engage the drive bail. Check the drive belt.
What to do if my Billy Goat F601S will not vacuum well?
If your Billy Goat Lawn and Garden Equipment isn't vacuuming well, it could be due to a dirty debris bag, a missing hose kit cap, a clogged nozzle or exhaust, too much debris, or improper nozzle height. To fix this, clean the debris bag by shaking or washing it. Check for the hose kit cap. Unclog the nozzle or exhaust. Allow air to feed with debris. Adjust the nozzle height so that it is closer to the debris.
Why is my Billy Goat Blower vibrating abnormally?
Abnormal vibration in your Billy Goat Blower could be due to a loose or out-of-balance impeller, or a loose engine. Check the impeller and replace it if required. Also, inspect the engine.
What causes the self-propelled drive on a Billy Goat Blower not to release?
If the self-propelled drive on your Billy Goat Blower won't release, it might be due to improper drive clutch cable adjustment or a kinked cable.
Why does the Billy Goat Blower nozzle scrape the ground?
If the nozzle of your Billy Goat Blower scrapes the ground even at the lowest height setting, it's likely that the nozzle height is out of adjustment. Adjust the nozzle height.
What to do if Billy Goat Vacuum Cleaner engine is locked?
If the engine of your Billy Goat Vacuum Cleaner is locked and won't pull over, it might be due to debris locked in the impeller or an engine problem. See page 7. Contact an engine service dealer for engine problems.
How to make Billy Goat Vacuum Cleaner go backwards?
To allow the Billy Goat Vacuum Cleaner unit to free-wheel backwards, push the unit slightly forward.
Why is my Billy Goat Vacuum Cleaner vibrating so much?
Abnormal vibration in your Billy Goat Vacuum Cleaner may be due to a loose or out-of-balance impeller, or a loose engine. Check the impeller and replace it if required. Also, check the engine.
Why is my Billy Goat Vacuum Cleaner not picking up leaves well?
If your Billy Goat Vacuum Cleaner isn't vacuuming well, consider these potential causes: * The debris bag might be dirty, requiring a cleaning (shaking or washing). * The hose kit cap could be missing. * The nozzle or exhaust might be clogged, needing unclogging. * There might be too much debris, restricting airflow. * The nozzle height may be improperly adjusted; adjust it closer to the debris.
General| Brand | Billy Goat |
|---|---|
| Model | F601S |
| Category | Lawn and Garden Equipment |
| Language | English |
To Next Page
